CAS LP-II Manuel de service télécharger pdf (Page 35)

8 System Options

CPD, where CZP = Calibrated Zero Point in counts, IZR is the Initial Zero Range value, & CPD is a

conversion factor called Counts Per Division.

ReZero Range: This is an allowable range from Initial Zero that the scale will go to zero from when you

press the ZERO key. The range is IZ

+ ((CAPACITY x RZR) / 100) x CPD, where IZ = Initial Zero Point in

counts, RZR is the ReZero Range value, & CPD is a conversion factor called Counts Per Division.

NOTE: Any changes made here will affect the NTEP Audit Trail counters (OPT counter only.)

8.1.4 Captions & Headings

For changes to Captions or Headings please consult your Authorized CAS Dealer. These changes are

only possible through Service Programming:

< SET: CAPTIONS & HEADINGS >

1.LABEL CAPTIONS

2.DISPLAY HEADINGS

The Label Captions options allow you to specify some of the Captions that get printed. An example of

a Caption is “TOTAL PRICE $” which usually appears above the Total Price box on some formats. These

need to change dynamically when toggling between weighing units (lb/kg).

The Display Headings options allow you to specify some of the wording that appears on the

REG/MGR/RPK display. These include “TOTAL PRICE $” , “PRICE lb/$”, etc. These too need to change

dynamically when toggling between weighing units (lb/kg).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 88 89

Pas de commentaire

CAS LP-II Manuel de service Page 35