CAS LP-II Manuel de service télécharger pdf (Page 54)

13 Audit Trails

< AUDIT TRAIL COUNTERS >

CALIBRATION COUNTER= 7

OPTION COUNTER= 14

13.1 Reading the Audit Trail Counters

1. Make sure that the Main Power is OFF (switch on left side of scale.)

2. Press and hold down the PRE PACK key.

3. While you are holding down the PRE PACK key, turn the Main Power ON.

4. Once you here a “chirp” release the PRE PACK key.

5. After a few seconds the scale will be in Audit Trail mode.

This is the Audit Trail Counter screen.

Calibration Counter: This counter is

incremented every time you

attempt to Span or Zero calibrate

or adjust, or every time you change

the gravity constant. If you use the

SAVE key or ENTER key from any of

the afore mentioned screens, the

scale will consider it an attempt to calibrate and the counter will be incremented. All of the screens

that can change this counter will be noted in this manual.

Option Counter: This counter is incremented every time you attempt to change or adjust any of the

various NTEP regulated options. If you use the SAVE key or ENTER key from any of the Weight Options

entry screens, the scale will consider it an attempt to change these options and the counter will be

incremented. All of the screens that can change this counter will be noted in this manual.

The Audit Trail eliminates the need of physically sealing the scale. It is up to the local inspector to

be informed of this and any scale’s sealing or Audit Trail procedures. If a physical seal is necessary, the

LP-2 can be sealed from the top of the scale (underneath the platter.) See the diagram on next page.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 88 89

Pas de commentaire

CAS LP-II Manuel de service Page 54