CAS LP-II Manuel de service télécharger pdf (Page 52)

12 Self Test Mode

12.6 Peel Off Test

< PRINTER PEEL-OFF TEST >

SENSOR CHECK : UNBLOCKED

< SET: FLASH MEMORY TEST >

1.Check NV Memory Links

2.Check NV Memory Records

3.Check NV Memory Index Table

4.Check NV Memory Fragmentation

5.Defragment NV Memory

At the Self Test Menu screen, press

the 5 key for Peel-Off Test. The

scale will then display the Printer

Peel-Off Test screen.

If you lay flat a piece of paper on

the left side of the Peel Bar, you

will see the UNBLOCKED status

change to BLOCKED. Once you remove the paper, you will see the status return to UNBLOCKED. If you

do not experience that behavior, run the Gap/Peel calibration and test again. If the problem persists,

you may need to change the Peel Sensor Assembly.

12.7 NV Memory Size

This will display the amount of used and available memory

12.8 NV Memory Test

At the Self Test Menu screen, press

the 6 key for NV Memory Test.

The following screen appears

Options 1-3 are self checks and

will simply return a value and go

back to the Flash Memory Test

screen. There is no need to

check these values, as they are

checked during power on.

Check NV Memory Fragmentation- This will give you the amount of free memory and how much of it is

fragmented. This value will be displayed and then will return to the Flash Memory Test screen.

Defragment NV Memory- This will clean up disk space by removing incomplete file fragments from the

hard drive on the scale. This should be done every few months as a precaution, but only must be done

when a defragment error occurs.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 88 89

Pas de commentaire

CAS LP-II Manuel de service Page 52